ServicesTPO Roofing
TPO Roofing in Avon, IN
Shingles need slope to shed water. The flat or nearly flat parts of your home, like a porch roof, an addition or a garage, need a sealed membrane instead. We install and repair TPO with hot-air welded seams, and we fix what is fixable before talking about tear-off.

What TPO is and where it belongs on a home
TPO (thermoplastic polyolefin) is a single-ply membrane, usually white, sold in 45 mil and 60 mil thicknesses. Its seams are fused with a hot-air welder rather than glued or taped, turning two sheets into one continuous layer of plastic. That makes it a fit for sections pitched below about 2 in 12, where wind-driven rain and meltwater would creep under shingle tabs.
On most houses TPO covers just one part of the roof: a rear addition, a covered porch, a sunroom or a low section between two gables. Those spots collect snow and drain slowly through Indiana's freeze-thaw months, exactly where an old rolled roof or patched shingles start leaking.
Repair comes first and replacement second. A lifted seam or a split near a pipe boot can often be cleaned and welded with a fresh patch. When the insulation underneath is saturated or the membrane has gone brittle, we explain why patching won't last and price a new membrane.

What a TPO job includes
- 01
Core check of the layers below
Before we price anything, we check whether the insulation and deck under the membrane are dry. Wet polyiso or soft plywood changes the job, so we find it first.
- 02
Seam welding and patching
Weathered TPO gets scrubbed with membrane cleaner so the patch fuses properly. We probe every weld with a seam probe after it cools to catch cold spots.
- 03
Insulation and cover board
On a full tear-off we lay tapered or flat polyiso with a cover board on top. Tapered board adds slope so water moves toward the drain or gutter edge instead of ponding.
- 04
Flashing and edge metal
Where the low roof meets a wall, we run membrane up the wall and lock it under a termination bar and counterflashing. We install new drip edge, pipe boots and curb flashing rather than reusing the old pieces.
- 05
Drainage at the edge
Water has to leave a low-slope roof somewhere. We set the edge detail, scupper or gutter connection so it drains cleanly, and we can tie it into new gutters if yours are undersized.
Questions about TPO Roofing?
Call(317) 943-0168Warning signs on a flat or low-pitch roof
Puddles that outlast the storm
Standing water that is still there two or three dry days after a rain points to a sagging deck or crushed insulation underneath. That pooled water ages the membrane faster and finds its way into any seam that never fully fused.
A lap edge that peels up
If you can slip a fingernail under the edge of a TPO seam, that weld most likely never fused all the way. Found early, it is a small patch job.
Ceiling stains under the porch or addition
Water travels along the deck before it drips, so the stain inside may sit a few feet from the actual opening. We trace it back from the roof side.
Wrinkles, bubbles or a shrinking membrane
Blisters mean moisture or air has gotten under the sheet. Membrane pulling back from the edge metal means the adhesive or fasteners have let go.
Cracked or chalky surface on an older roof
Aged TPO and old modified bitumen turn brittle. If the surface cracks when folded, it will not take a weld, and patching stops making sense.
How a TPO job goes
- 1
Free inspection with photos
We walk the low-slope section, probe the seams and flashing and look for wet insulation. You receive photos of the findings and a clear repair-or-replace answer.
- 2
Estimate in writing
Membrane thickness, insulation, flashing and edge metal each get their own line, so you know what every part of the price covers.
- 3
Tear-off and deck work
On a new roof we remove the old one down to the deck, replace rotted sheathing and install insulation and cover board that same day, so the area is never left open.
- 4
Membrane, welding and cleanup
Depending on the deck, the TPO is fully adhered or mechanically fastened, and then each seam is welded and probed. We clean up debris and pass a magnet over the yard for fasteners before leaving.
What moves the price of TPO work
A repair is priced by the damage we find, and a replacement by square footage and what sits under the membrane. We do not quote from the street. Financing is available if a new membrane is the right call.
- Condition below the membrane
- Dry insulation can sometimes stay. Wet insulation and soft decking have to come out, and that adds labor and material.
- Membrane thickness
- 60 mil costs more than 45 mil but carries more top ply over the reinforcing scrim, which helps on roofs that see foot traffic or hold snow.
- Penetrations and wall tie-ins
- Every vent, pipe, skylight curb and wall transition needs its own flashing detail. A small roof full of them can take longer than a large open one.
- Access and size
- A porch roof reached from the ground is simpler than a second-story low section that needs material carried over the main roof.
TPO roof questions
Can TPO be installed over my current flat roof?
Sometimes, if there is only one existing layer and it is dry and solid. We check for moisture first. Covering wet material traps the water and shortens the new membrane's life, so in that case we recommend a tear-off.
Is a white roof a problem in an Indiana winter?
Not much. White TPO reflects summer heat, so rooms under a sunroom or addition stay cooler. In winter the roof is often under snow, and the insulation beneath the membrane does most of the work of keeping heat inside.
Can an older TPO roof be patched?
Often, if the membrane still flexes. We clean the old sheet and weld new material over the damage. If the sheet is brittle or has lost most of its top ply, a weld won't hold reliably, and we say so rather than sell a patch that fails next season.
Why not put shingles on my low porch roof?
Shingles rely on gravity and overlap to shed water. Below about 2 in 12 pitch, rain and meltwater can back up under them and leak. A welded membrane has no laps for water to get beneath.
Do you help when a storm damages a flat roof?
Yes. We work with homeowners and insurance companies on storm damage claims and document the damage with photos and measurements. Our Storm Damage Repair page walks through the process.
Find out whether your flat roof needs a patch or a new membrane
We will check the seams, flashing and insulation, then show you photos and give you a straight repair-or-replace answer. The inspection costs you nothing.